Essence We.R Guía de usuario descargar pdf (Pagina 32)

Installation of the WeR@Home™ System

WeR@Home

™

System User Guide

Figure 7: Insertion of LAN Cable into the CCU Socket

The CCU back panel LAN (RJ45) socket provides two (2) LED status indications, active in accordance with the

IEEE 802.3u standard, as a convenient means of determining the mode of operation of the network:

i. LED1 (Green) is the Link Activity LED.

It will lit steady once the network transceiver detects a valid link and will blink upon link activity 4.

(transmit/receive).

ii. LED2 (Amber) is the Link Speed LED.

It will turn ON once the detected link speed is 100Mbit/Sec and will turn OFF once the detected link 5.

speed is 10Mbit/Sec. A blinking LED2 indicates communication collision.

If there is no Internet connection available or the LAN cable is not connected, the SIM-card will be 6.

used as the primary connection channel between the WeR@Home

™

system and the WeR@Home

™

server.

Note: If both the SIM-card and the LAN cable are installed, the Internet will be the

primary communication method and the cellular channel will be used for backup.

Insert the backup battery into the battery cavity, above the SIM-card. 7.

Note: Battery’s label should be facing up and the battery’s contacts – aiming towards

the base of the CCU.

LED 1

LED 2

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 290 291

Sin comentarios

Essence We.R Guía de usuario Pagina 32