
Installation of the WeR@Home™ System
WeR@Home
™
System User Guide
Figure 82: Dot Alignment of the Magnetic Sensor Units
3.8.2.2 Installing the Transmitter Unit with Screws
1. Release the Transmitter unit’s base by inserting a coin into one of the edge slots, as demonstrated in the
above Figure 80, and twist it to open the cover.
2. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 83 below).
Figure 83: Magnetic Sensor Transmitter Unit Base with Screws
3. Place and hold the base on the desired mounting location on the window/door frame and mark the
drilling locations (the above-mentioned punch-outs 1 and 2).
4. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the two (2) screws.
Comentarios a estos manuales