Essence We.R Guía de usuario descargar pdf (Pagina 233)

Maintenance of the WeR@Home™ System

System User Guide

233

Figure 199: Inserting Batteries into the Motion Detector

2. Return the Motion Detector back onto its mounting base.

The insertion of batteries into the Motion Detector triggers a bonding process in which the Motion Detector

communicates with the CCU to re-instate it into the CCU peripherals’ inventory.

Note: There is no need to perform “Add Device” process following batteries

replacement since the Motion Detector is already defined in the WeR@Home

™

system.

But, replacing the batteries will trigger the Walk Test Mode (see paragraph 3.7.4.1

above) to ensure proper battery replacement.

5.1.4 Replacing the Magnetic Sensor (MGL) Battery

For its operation, the MGL needs single 1.5V AA-size Alkaline battery.

5.1.4.1 Removing the Old Batteries

There is a need to dismount the Magnetic Sensor (Transmitter unit only) to allow replacement of the battery.

To dismount the Magnetic Sensor:

1. Insert a flat screw driver (or coin) into one of the edge slots as demonstrated in Figure 200 below.

2. Twist it to raise the cover (body) edge.

3. Pull the body strait out of the base’s shoulders.

1 2 ... 228 229 230 231 232 233 234 235 236 237 238 ... 290 291

Sin comentarios

Essence We.R Guía de usuario Pagina 233