Essence We.R Guía de usuario descargar pdf (Pagina 146)

Installation of the WeR@Home™ System

146

WeR@Home

™

System User Guide

3.11.2.3 Installing the Flood Detector Sensor Unit with Screws

1. Place and hold the Sensor Unit base on the desired mounting location and mark the drilling locations.

2. Drill the holes; insert two (2) dowels if needed, place the Sensor Unit base over them and screw in the two

(2) screws.

Figure 119: Mounting the Sensor Unit with Screws

3.11.2.4 Installing Transmitter Unit with Pre-attached Double-side Tape

The pre-attached double-sided tape will be mostly utilized for installation of the Transmitter Unit.

1. Release the Transmitter Unit base (see above Figure 117).

2. Peel the tapes’ protective covers.

3. Attach the base to its designated location while applying slight pressure.

4. Attach the Transmitter Unit back to its base.

3.11.2.5 Installing Sensor Unit with Pre-attached Double-side Tape

Pre-attached double-sided tape will be mostly utilized for the installation of the Sensor Unit.

1. Peel the tapes’ protective covers.

2. Attach the base to its designated location while applying slight pressure.

1 2 ... 141 142 143 144 145 146 147 148 149 150 151 ... 290 291

Sin comentarios

Essence We.R Guía de usuario Pagina 146