Essence We.R Guía de usuario descargar pdf (Pagina 102)

Installation of the WeR@Home™ System

102

WeR@Home

™

System User Guide

demonstrated in Figure 70 above.

2. For Flat Wall Mounting:

i. Use a flat screwdriver to remove the punch-outs 1 and 2 (see Figure 71 above).

ii. Clean the surface where the Motion Detector is to be installed.

iii. Place and hold the base on the desired mounting location and mark the drilling locations (the

above-mentioned punch-outs 1 and 2).

iv. Drill the holes; insert two (2) dowels if needed, place the base over them and screw in the two (2)

screws.

3. For Corner Mounting:

i. Repeat the above while using punch-outs 3 to 8 as required.

3.7.2.3 Installing with Pre-attached Double-side Tape

1. Release the Motion Detector wall mounting base (above Figure 70).

2. Peel the tapes’ protective covers where needed (position pending).

3. Attach the wall mounting base to its designated location while applying slight pressure.

4. Slide the Motion Detector into the wall mounting base.

3.7.2.4 Dismounting the Motion Detector

For dismounting the Motion Detector from the wall (i.e. in case of battery replacement), press the wall

mounting base's tab at the bottom of the Motion Detector and slide it downwards simultaneously, as

demonstrated in the below Figure 72.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 290 291

Sin comentarios

Essence We.R Guía de usuario Pagina 102