Essence We.R Guía de usuario descargar pdf (Pagina 31)

Installation of the WeR@Home™ System

System User Guide

3.2.2.1 CCU Positioning Recommendations

The CCU should be installed on:

n A flat surface.

n In a central home/office location with:

˜ Unshielded adequate cellular coverage (if cellular communication is to be used).

˜ Close to an Internet connection outlet (modem/router connection, if Internet communication

is to be used).

The CCU must be activated and the system must be registered with the Service Provider (or the distributer) to

enable its proper operation.

The following need to be executed for the setup and activation of the CCU:

Remove the back cover of the CCU to reveal the battery/SIM-card compartment. 1.

In case cellular is intended to be used for external communication – insert the SIM-card, with its 2.

contacts facing down, as illustrated in Figure 6 below.

Note: Refer to the graphic representation of the SIM-card engraved onto the plastic

bottom of the cavity, next to the card’s designated location.

Figure 6: Insertion of the SIM-card

In case the Internet is intend to be used as the primary external communication channel: 3.

Plug the LAN cable into the RJ45 socket on the back panel of the CCU and its other end into a network socket

(in the Internet router or modem).

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 290 291

Sin comentarios

Essence We.R Guía de usuario Pagina 31